Lower kitchen cabinet shelf
Posted: Thu Nov 10, 2011 11:48 am
Of course it's the lower one! It's starting to warp, sag, bow in the middle. The dangerous part is I'm thinking.....of removing the side panel next to the refrigerator. Then I could drill some holes and pull up and out the shelf (pieces) from that end. With the refrigerator out of the way I can have another board cut and slide it (5' long) back in and set it back on the bracing that I will buildup with some back to front bracing.
The toughest part of this to me is removing the flimsy end panel without destroying it. Not to say a piece of luan with some stain couldn't be used to replace it.
So, if you've got any suggestions, recommendations, experience, I'd sure like to read them. Thanks so much.
The toughest part of this to me is removing the flimsy end panel without destroying it. Not to say a piece of luan with some stain couldn't be used to replace it.
So, if you've got any suggestions, recommendations, experience, I'd sure like to read them. Thanks so much.