Model #DGAT070BDE
We bought the trailer and it was set up for nat. gas we are using propane. The orfice that came in the little bag is size 093, the door panel says to use 042 for propane. But also says the the propane orfice is in the bag. Which orfice should I use? and where to get one? thanks in advance.
Nathan
coleman furnace orfice
Hi Nathan,
The .093 is the correct LP orifice . You'll also have to convert the gas valve by inverting the conversion stem if it is still set for NG.
Then have gas pressure changed to LP pressure and have a Tech adjust burner flame if needed and run a few cycles to be sure it is operating properly.
Take care and best wishes,
Robert
The .093 is the correct LP orifice . You'll also have to convert the gas valve by inverting the conversion stem if it is still set for NG.
Then have gas pressure changed to LP pressure and have a Tech adjust burner flame if needed and run a few cycles to be sure it is operating properly.
Take care and best wishes,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Eb12eb Coleman furnace 4 speed help.
by Johnwayne892000 » Thu Aug 30, 2018 7:37 pm » in Coleman Service & Repair - 0 Replies
- 24906 Views
-
Last post by Johnwayne892000
Thu Aug 30, 2018 7:37 pm
-
-
-
Coleman 6806a furnace doesn't stop heating even with tstat disconnected. Any ideas?
by Neighbor Bill » Mon Dec 31, 2018 1:01 pm » in Coleman Service & Repair - 1 Replies
- 41592 Views
-
Last post by Neighbor Bill
Mon Dec 31, 2018 1:06 pm
-
-
-
DGAT Series furnace air-conditioning issue
by minnie1967 » Thu Jul 13, 2017 9:48 am » in Coleman Service & Repair - 0 Replies
- 61845 Views
-
Last post by minnie1967
Thu Jul 13, 2017 9:48 am
-
-
-
Acceptable HEAT RISE number for this 20-yr. old furnace.
by justplumducky » Tue Aug 29, 2017 5:33 pm » in Nordyne Service & Repair - 0 Replies
- 44300 Views
-
Last post by justplumducky
Tue Aug 29, 2017 5:33 pm
-
-
-
Can't get the furnace cover to go on
by nestsman » Sat Sep 30, 2017 4:53 pm » in Nordyne Service & Repair - 2 Replies
- 48308 Views
-
Last post by tkrueger
Sat May 05, 2018 9:12 pm
-