Pex tube
Moderators: Greg, Mark, mhrAJ333, JD
-
- Posts: 6
- Joined: Sat Sep 17, 2016 6:54 pm
Hi again..as I'm redoing my whole MH, I am doing the water supply lines as well..I'm going with PEX tube..is there a specific size?..how about type?..I've seen an Oxygen barrier type..anyone know what that is?..thank you
There are a few ways to do this. Some use 3/4" as a main supply line to the hot water tank and then down the middle to the other end, you can then run 1/2" off of the main to your faucets. Doing it this way will give you better flow to the faucets.
You can also use a manifold system also.
Any way that you do it make sure you use brass or stainless valves at every faucet. Use either Ball or Gate valves, they may cost a little more but they work when you need them.
Greg
You can also use a manifold system also.
Any way that you do it make sure you use brass or stainless valves at every faucet. Use either Ball or Gate valves, they may cost a little more but they work when you need them.
Greg
"If I can't fix it, I can screw it up so bad no one else can either."
-
- Similar Topics
- Replies
- Views
- Last post
-
-
I need input on best way to hang new copper or pex pipes from underside mobilehome without opening up belly board
by waitingtohear » Mon Jun 11, 2018 12:21 am » in Mobile Home Repair - 7 Replies
- 83037 Views
-
Last post by waitingtohear
Mon Jul 02, 2018 5:39 pm
-
-
- 2 Replies
- 19403 Views
-
Last post by Mark440
Tue Sep 20, 2022 2:15 pm