Roof Leak Repair Question

Repair help for the do-it-yourselfer.
For mobile home parts, click here.

Moderators: Greg, Mark, mhrAJ333, JD

Locked
rockncountry101
Posts: 79
Joined: Sun Mar 11, 2012 3:56 pm

Thu Feb 13, 2014 1:24 pm

I have noticed in my house at the very edge where the ceiling meets the wall there is some moisture there is a wet spot when it rains. I can tell by the dampness and also there is a ring from water damage. It's not exactly a leak because water doesn't come out. It's just damp. I tried to put some caulk on the outside where the sections of sheet metal connect on the roof. I also have caulking on the seal between the wall and roof. Any suggestions would be greatly appreciated.


User avatar
Greg
Moderator
Posts: 5683
Joined: Wed Feb 28, 2007 8:01 pm
Location: Weedsport, NY
Contact:

Thu Feb 13, 2014 7:42 pm

If it's a metal roof, try coating it. Take a close look and treat ANYTHING that looks suspicious as a leak.

Greg
"If I can't fix it, I can screw it up so bad no one else can either."

calderhill
Posts: 51
Joined: Sat Aug 17, 2013 1:37 pm
Location: Oneonta, NY

Fri Feb 14, 2014 9:08 am

The bad news is it could be a major leak and the insulation is absorbing the water and spreading it over a greater area. Take care of it now before it progresses down the wall.

User avatar
JD
Site Admin
Posts: 2690
Joined: Sun Feb 25, 2007 11:57 pm
Location: Fresno, CA
Contact:

Sat Feb 15, 2014 12:44 pm

Yes, a re-coat sounds in order. but also take a look at the roof metal where it bends over the edge to the j-channel, especially where you see dents or hard line creases. When the roof expands and contracts, it will often makes tiny stress fractures near these dents. IF the bend is a hard crease, it can also happen on any part of the edge. Just recoating the edge will usually cover these fractures, as the sealant should go up 4" of so on to the top parts of the roof edge, but if there is creasing, you should also add the polyester roof fabric to the top of the fracture to stop the cracking of the roof sealant. This will not stop the continued cracking of the metal fracture, but these things remain fairly small and should be fine under fabric and elastomeric sealant.
☯JD♫
Today is PERFECT!

All information and advice given is for entertainment and informational purposes only. The person doing the work is solely responsible to insure that their work complies with their local building code and OSHA safety regulations.

Locked