Blend Air System

Post all other heating and cooling questions here.

Moderators: Greg, Mark

Post Reply
dd716ted
Posts: 29
Joined: Wed Aug 22, 2007 5:17 pm

Sat Mar 07, 2015 4:08 pm

This past week I had a new roof put on my mfg home... The roofers removed the intake vent for the blend air system (the one that was about a foot high) and replaced it with a normal roof vent which is only 2 inches off the surface of the roof.. I think being this close to the roof will create a heat / moisture issue when drawing in outside air.. I just can't find any documentation to make the roofer install the correct vent that they removed. Am looking for help.. attached picture describes my issues..
Attachments
roofprobs.jpg
roofprobs.jpg (63.66 KiB) Viewed 3216 times


jpingram5
Posts: 205
Joined: Sun Dec 05, 2010 5:34 pm
Location: Orefield, PA
Contact:

Sat Mar 07, 2015 7:04 pm

It might also be an issue when if it snows where you are. I mean I would just ask the guy to put one on that's at least 12 inches clearance. That should be a real easy fix for the roofer.
2009 Skyline Sunwood Premier 14 x 80

Post Reply