Hello when winter started I turned my heater on for the first time and was working fine. The next time it was used(month later) it took a few minutes before it started blowing hot air. The third time it was used the blower would come on but no hot air. Do I have a bad heating element or sequencer? How do I check them to see which is bad? Can I just check voltage with a meter and what voltage should it be? Any help would be greatly appreciated.
Thanks
Nordyne E1EH-015HA
Normal operation can be checked with a meter able to measure 240v ac. When the thermostat calls for heat the sequencer will turn on the blower and 1 element. Check for power at each element with the meter. As the furnace continues to run you will hear a series of clicks. Thats the sequencer bringing the other elements online. As you hear those clicks continue to check power at each element. At some point all elements should have power, if not the sequencer is bad. If they have power and are not heating then you need to do a continuity test on each element to see which ones are bad. Be sure to do that with the power OFF!
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Nordyne Mod. E1EH-015HA split unit/eliminate cooling?
by carolina jim » Thu Oct 24, 2019 8:33 am » in Nordyne Service & Repair - 0 Replies
- 36554 Views
-
Last post by carolina jim
Thu Oct 24, 2019 8:33 am
-
-
- 2 Replies
- 23024 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:35 am
-
-
Intertherm/Nordyne feh-015ha furnace issues blower not working, unit will only turn off at breaker box
by onmypath78 » Sat Mar 16, 2019 12:11 pm » in Nordyne Service & Repair - 0 Replies
- 158164 Views
-
Last post by onmypath78
Sat Mar 16, 2019 12:11 pm
-
-
-
Question about burned wiring on e2eb-015ha
by thomasclay » Thu Sep 14, 2017 5:37 pm » in Nordyne Service & Repair - 0 Replies
- 61891 Views
-
Last post by thomasclay
Thu Sep 14, 2017 5:37 pm
-
-
- 0 Replies
- 74363 Views
-
Last post by newguy47
Thu Aug 16, 2018 8:21 pm