I really appreciate your help, I am currently having trouble with my pressure sensor. In the last few days my furnace has failed to ignite due to a "Pressure switch is open" failure. It has tripped due to this error 3 or 4 times in the last 3 days. the induction fan is running, but the furnace continues to blink twice indication pressure switch is open. After taking off the cover and messing around with the connections it randomly stops blinking and starts to fire up. I am wondering (hoping) that this is a simple pressure switch failure but I am not sure. I had the furnace completely replaced less than a year ago. I've also noticed a couple times when the furnace is firing up the gas valve clicks loudly 3 or 4 times as opposed to the normal 1 time to open up and ignite the flame.
Worst case scenario, if I need heat desperately (temperatures can get to -40 where I live) is there anything I can do with the wires and/or sensor to bypass this error in the meantime while I try and fix it?
Thank you very much.
M1MB070AW Pressure switch open lockout problems
Pressure switch is bad. You can try swapping the tubes on it, sometimes that works but only for a while. The make those pressure switches with different ratings. Try to get one with a .18 rating on it. The lighter switch works better when the combustion motor fan blades get dirty and don't move air as efficiently. If you can't find one go with the OEM .20 switch.
In a pinch, sucking and blowing lightly on one of the tubes after you remove it from the combustion motor can get you going. The reason you can't jump anything out is that the control board registers the switch being open at the beginning of the cycle and it's closing after calling for the combustion motor to turn on.
In a pinch, sucking and blowing lightly on one of the tubes after you remove it from the combustion motor can get you going. The reason you can't jump anything out is that the control board registers the switch being open at the beginning of the cycle and it's closing after calling for the combustion motor to turn on.
-
- Posts: 7
- Joined: Thu Jan 19, 2012 9:22 pm
Thanks a ton. I got a new switch installed a couple weeks ago before I headed out of town and its working good so far. I just got the OEM one put in though. Thanks for the help!
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 15372 Views
-
Last post by mdnagel
Tue Nov 07, 2017 2:37 am
-
-
Skirt vents. Should they be open all year ?
by JustRayInWi » Sat Sep 12, 2020 4:40 pm » in Mobile Home Repair - 4 Replies
- 15321 Views
-
Last post by JustRayInWi
Mon Oct 12, 2020 2:23 pm
-
-
-
Could open crawlspace (no skirting) provide better ventilation?
by thedavidbieda » Sat Nov 20, 2021 5:51 pm » in Mobile Home Repair - 0 Replies
- 118844 Views
-
Last post by thedavidbieda
Sat Nov 20, 2021 5:51 pm
-
-
- 1 Replies
- 23324 Views
-
Last post by Greg
Sat Jul 29, 2017 7:14 pm
-
-
EB15B Limit switch part # help
by ferret13sj » Thu Jan 18, 2018 11:46 pm » in Coleman Service & Repair - 0 Replies
- 45574 Views
-
Last post by ferret13sj
Thu Jan 18, 2018 11:46 pm
-