My wife and I recently purchased a 1980 singlewide mobile home... It has a full length, screened in front porch, the porch is on a slab at ground level, the roof for the porch extends OVER the trailer, and connects to a secondary wall on the opposite side of the trailer..
Overall, we think it's a solid place.
However... the back door refuses to close all the way.. We had to replace the door knob/lock set because the key for the backdoor had been lost.. and I noticed that the previous owner had done a fairly horrible job of replacing the lockset previously.
I wound up using spray-in foam sealant to just seal off the entire door, because I could see daylight through it.
I do, however, eventually want to FIX it. I think I may need to replace the entire frame and door, but this is the first mobile home I've ever lived in..
I've installed doors and frames in site-built homes, and it's fairly simple to do..
After all the background info, here is my question.. how difficult should I expect it to be to completely remove and replace the entire door, frame and all?
Damaged door frame on older singlewide
Moderators: Greg, Mark, mhrAJ333, JD
Hi & welcome. Due to the year of your home it probably has the smaller "trailer" doors unless some one has changed it. If you have enough head room you can simply install a standard sized stick built door. Make sure you have enough room for at least a double if not a triple top header for roof support. Remember there will also be wires there you will need to work around.
Greg
Greg
"If I can't fix it, I can screw it up so bad no one else can either."
-
- Posts: 195
- Joined: Fri Nov 13, 2009 2:09 am
- Location: Indiana
Best idea is to replace with a standard sized door, as Greg posted. Most stores sell a pre-hung door with frame at a reasonable price, since its a "back" door you don't need anything too fancy.
You can beef up the door rough opening while you have everything apart for extra security, as well as adding some insulation. Finally, make sure you seal up the door frame from the outside to keep out leaks.
You can beef up the door rough opening while you have everything apart for extra security, as well as adding some insulation. Finally, make sure you seal up the door frame from the outside to keep out leaks.
Tip your bartender.....
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 4701 Views
-
Last post by Mtrumpower002
Thu Aug 08, 2019 6:54 pm
-
-
Filters for ceiling vents in older mobile home?
by Seeker-2019 » Mon Sep 30, 2019 5:42 pm » in All Other HVAC Questions - 0 Replies
- 26609 Views
-
Last post by Seeker-2019
Mon Sep 30, 2019 5:42 pm
-
-
-
how do I replace a front door with built in storm door?
by truckinusa » Thu Oct 18, 2018 9:30 pm » in Mobile Home Repair - 0 Replies
- 35762 Views
-
Last post by truckinusa
Thu Oct 18, 2018 9:30 pm
-
-
-
What's the difference between regular door knobs and mobile home door knobs?
by NurseWizzle » Fri Aug 16, 2019 6:55 pm » in Mobile Home Repair - 1 Replies
- 56167 Views
-
Last post by MelissaD
Wed Jan 04, 2023 12:02 pm
-
-
- 2 Replies
- 16149 Views
-
Last post by JenniferK
Fri Nov 24, 2017 1:55 am