ac not up to par
need to see if i could get some help.my ac is blowing 65 degrees but the house is still warm.give me some ideas.goodman condenser and coil.heat is intertherm
Go here and look at cleaning your a/c and cleaning your furnace blower motor articles:
http://www.mobilehomerepair.com/hvac/articleshvac.html
That will show how to clean outside condenser, inside a-coil and blower motor, wheel and housing.
Clean or replace filter.
If still not working good, wrap fingers around biggest copper refrigerant line as it enters a-coil and see if it is cold.
May be low on refrigerant or have a restriction in discharge line .
Thanks,
Robert
http://www.mobilehomerepair.com/hvac/articleshvac.html
That will show how to clean outside condenser, inside a-coil and blower motor, wheel and housing.
Clean or replace filter.
If still not working good, wrap fingers around biggest copper refrigerant line as it enters a-coil and see if it is cold.
May be low on refrigerant or have a restriction in discharge line .
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
robert,on a 95 degree day,what should my pressures be.think the freon is ok though. my opinion, i need to take the coil out and clean it.tried once before and burned up my blower motor.im replacing my crossover tomorrow,my flex is destroyed.let me know about the pressures when you can buddy.thanks.
Hi,
The link I gave ya will tell and show how to clean everything without removing the a-coil.
Sometimes, removal is needed, but most times it's not.
Was that line cold I asked about ?
Too many variables go into charging a unit, too many for me to give an accurate pressure without being there.
Thanks,
Robert
The link I gave ya will tell and show how to clean everything without removing the a-coil.
Sometimes, removal is needed, but most times it's not.
Was that line cold I asked about ?
Too many variables go into charging a unit, too many for me to give an accurate pressure without being there.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 70763 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 111479 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-
-
-
Heat strips are on, but not the fan.
by Forestbrook » Sat Dec 08, 2018 6:09 pm » in Coleman Service & Repair - 0 Replies
- 40012 Views
-
Last post by Forestbrook
Sat Dec 08, 2018 6:09 pm
-
-
- 2 Replies
- 24898 Views
-
Last post by plumducky
Tue Dec 10, 2019 3:59 pm
-
-
Intertherm/Nordyne feh-015ha furnace issues blower not working, unit will only turn off at breaker box
by onmypath78 » Sat Mar 16, 2019 12:11 pm » in Nordyne Service & Repair - 0 Replies
- 160273 Views
-
Last post by onmypath78
Sat Mar 16, 2019 12:11 pm
-