Page 1 of 1

setup diagram

Posted: Mon Mar 17, 2008 10:55 am
by lefties
on this setup diagram,,,do the outside perimiter white slots represent perimiter blocking or windows?? ThxImage

Posted: Mon Mar 17, 2008 11:30 am
by Mark
What you are showing is just a floor plan. The white slots are windows. A set-up diagram will show placement of the blockings & such.

Mark

RE: setup diagram

Posted: Mon Mar 17, 2008 12:07 pm
by lefties
thx

Posted: Tue Mar 18, 2008 1:37 am
by Demolition
In Arkansas the Mobile Home Commission has a booklet they will mail, that has the basic requirements for setting up a mobile home.
Every house is a little bit different so check your local codes.
One thing people overlook is setting blocks under the entry doors. Then the door dont shut right and it leads to lots of cussing.

Posted: Tue Mar 18, 2008 10:05 am
by Manitoba Bill
Demolition wrote: One thing people overlook is setting blocks under the entry doors. Then the door don't shut right and it leads to lots of cussing.

I have outriggers under my perimeter. So how, exactly, do you install blocks when you have frost heave?

Do these show up in installation diagrams?

Posted: Sun Mar 23, 2008 6:02 pm
by Demolition
Frost Heave? The only frost we have is on
the car windows. It usually thaws by 9 AM

In the Arkansas Delta, the soil is very soft.
The trick is to balance the weight in the mobile home,
so the whole house sinks evenly.

Posted: Sun Mar 23, 2008 6:43 pm
by Greg
About the only way around frost heave is below the frost line footers, either block foundation or cement piers sunk below frost line. Greg

RE: setup diagram

Posted: Sun Mar 23, 2008 8:37 pm
by Manitoba Bill
I checked about 3 mobiles around me and not ONE has any perimeter blocking so your advice doesn't apply around here and actually would make it worse.

And can you show me in any diagrams where they are used to back up your opinion?

Posted: Mon Mar 24, 2008 4:26 pm
by Mark
Hey Bill,

What's with all the raised hair over perimeter blocking? I reread this post 3 times and didn't see one question of anyone asking about installing perimeter blocking. The original poster was asking for help in deciphering markings on a floor plan. Nobody mentioned anything about installing perimeter blocks that I read.

By the way, I like your scientific survey of 3 mobile homes.

A home that has good outriggers probably don't need perimeter blocking except at the doors and big windows. An outrigger is an outward metal extension from the main frame.

Most all homes have perimeter blocking underneath doors and large windows. During frost heave, it helps keep the doors aligned as the blocks are suppose to heave evenly with the ground. It's not a perfect system, but it must work as its written into most all the manufacturer set-up manuals of the last 10+ years.

If people in homes without outriggers need perimeter blocking, the blocks would work best if frost heave wasn't a big issue. One way to stop or reduce frost heave is to install insulated skirting. After I installed new insulated skirting several years ago, it has not frozen underneath my home. I have had no frost heave. Things quit moving in my home.

Personally I would install outriggers than mess with perimeter blocking. You can find outriggers towards the bottom of this page: http://www.mobilehomerepair.com/order.htm#catalog

Mark