Page 1 of 1
Intertherm A/C Help
Posted: Thu Mar 13, 2008 2:39 am
by carterw65
Hello All!
I have a 16x80 MH and I need to put A/C in it. I am considering a 3 ton unit, but I am not sure what A-Coil I need. I think it is uncased and here is the info on the Furnace/Exchanger.
Model # E1EH-015HA
53,500 BTU
Width 20 inches
Depth 24 or 25 inches measuring casing
Height 23 1/2 inches
Could anyone offer some advice?
Thanks so much,
Bill
RE: Intertherm A/C Help
Posted: Thu Mar 13, 2008 3:21 am
by Robert
Hi Bill,
Go here to our Nordyne (Intertherm) A/C page:
http://www.mobilehomerepair.com/NordyneAC.html
It would depend on what Seer outside Condenser you got. We have some 10/12 Seer when we can get them (rare) and have 13 Seer.
You should get a Tech to do a ACCA Manual J Load Calc to determine correct size unit needed.
I am going to move this to the Nordyne forum tonight or tomorrow. Follow it there once it is moved.
Thanks,
Robert
RE: Intertherm A/C Help
Posted: Thu Mar 13, 2008 4:54 am
by carterw65
Robert,
Thanks for the reply. I do not have any of the A/C parts yet. No condensor or anything. The Mobile Home place said I needed a 3 ton 10 seer, but I was hoping to get a 13 seer for economy sake.
Thanks,
Bill
RE: Intertherm A/C Help
Posted: Thu Mar 13, 2008 5:06 am
by Robert
Hi Bill,
Nobody can say what size you need with certainty without doing the Load calc first.
They no longer make anything under 13 Seer, so any 10/12 Seer is only what is left unsold at this point.
If you go to the a/c store page link I gave, we have 3 Ton / 13 Seer available.
The A-Coils are all we sell along with any parts needed.
We do not sell condensers or furnaces.
Thanks,
Robert
RE: Intertherm A/C Help
Posted: Thu Mar 13, 2008 11:40 am
by carterw65
Robert,
I am going to try to get the calc done. I have been trying to figure out a parts list. I know that I need a condensor, a-coil, copper lines, thermostat. Is there anything else I need, electronics maybe? I have a place to get the condensor, but I am sure I will need to get the a-coil from you.
Bill
RE: Intertherm A/C Help
Posted: Thu Mar 13, 2008 4:59 pm
by Robert
Hi Bill,
Condenser pad, liquid line filter drier, wall disconnect box, electrical whip from disconnect to condenser, a-coil drain line, drainline trap, depending on furnace and t-stat, may need an a/c control box, may need an upgraded blower motor if yours is not a/c compatible.
Thanks,
Robert