Rigid foam insulation

Repair help for the do-it-yourselfer.
For mobile home parts, click here.

Moderators: Greg, Mark, mhrAJ333, JD

Post Reply
m5online
Posts: 14
Joined: Mon Jul 20, 2015 10:53 am

Sat Jul 21, 2018 9:43 pm

Greets all,

I’m considering putting in 1 inch or 1/2 inch rigid foam insulation in my exterior walls. I’ll use the cans of spray foam filler to seal up the edges. I was planning on laying it on top of my current insulation (whatever may be there, haven’t looked yet). I’ll be doing this by removing my interior wall board panels (the cheap stuff) and replacing with drywall. Main reason is my place is very leaky. I tried using window film last summer on my old windows do make them air tight and didn’t make a dent on my summer energy bills. My goal is is to make the exterior walls as tight as possible. Can’t really afford new siding.

I’m also considering ripping out my old carpet and rolling on that roof insulating paint to seal up my subfloor.

My place is a 1972 double wide that’s about 1000 square feet.

Will be doing this project in phases, 1 room a month probably.

Thoughts?


User avatar
Greg
Moderator
Posts: 5453
Joined: Wed Feb 28, 2007 8:01 pm
Location: Weedsport, NY
Contact:

Sun Jul 22, 2018 8:27 am

I think I would have an energy audit done first to find out where the problems really are. If you have the old jealousy windows that right there could be the major problem.

Greg
"If I can't fix it, I can screw it up so bad no one else can either."

Post Reply