Need refurbished gas valve & tube
Posted: Sat Feb 08, 2014 11:42 am
Robert!
I replaced the limit switch a while back from you guys that you had to rebuild for me hoping it would solve my Intertherm model MGH-055-ABW36C67 gas furnace not heating up hot enough but did not resolve the problem.
The gas valve model is 36C67 Type177 part# is 6243700
The weather here has been so cold with a lot of snow.
I want to go ahead & purchase this valve & perhaps the tube as well with the orifice intact.
Let me know if it will work in my furnace.
I'm having to use 4 floor heaters & all are safe but makes my heating bill sky high.
Two are a electric oil radiator type & the other two are electric grid type.
No dangerous type space heaters used cause I heard they are not safe to use for causing fires.
They are too high to use anyway.
I want them as soon as possible so send me the correct ones once I see the prices.
I did at one time a long while back removed the orifice assembly & cleaned out the orifice for possible spider webs & trash with a cleaning device & reinstalled & still the same.
I tampered with the adjustable pilot valve screw a long while back up some to keep the pilot light from going out when the wind was blowing hard.
The flame would come out weak & flickering & not blowing the flame out strong.
I suspected it may have a crack in the heat exchanger but inspected it myself & it showed to be ok.
I do have some small cut open places in the under belly where I had to gain access to some grey plastic type polybutholene (sorry for the misspell), water pipes & repair the leaks at the hot pipes t-joints 1/2 to 3/4 inch fittings.
The belly warp had no affect on the furnace heating up cause it worked fine before when the underbelly was open when it was working before.
They seem to be the only ones that split into.
The reason I haven't been on here in quite awhile is I was diog. with Lukemia earlier stage back in June & Have been taking chemo & had to have a blood transfusion & two bone marrow biopsies & soon to have a bone marrow transplant.
On my last stage of Chemo for 6 months & should be ok after that the doctor told me.
Let me know something soon!
Thanks!
David
I replaced the limit switch a while back from you guys that you had to rebuild for me hoping it would solve my Intertherm model MGH-055-ABW36C67 gas furnace not heating up hot enough but did not resolve the problem.
The gas valve model is 36C67 Type177 part# is 6243700
The weather here has been so cold with a lot of snow.
I want to go ahead & purchase this valve & perhaps the tube as well with the orifice intact.
Let me know if it will work in my furnace.
I'm having to use 4 floor heaters & all are safe but makes my heating bill sky high.
Two are a electric oil radiator type & the other two are electric grid type.
No dangerous type space heaters used cause I heard they are not safe to use for causing fires.
They are too high to use anyway.
I want them as soon as possible so send me the correct ones once I see the prices.
I did at one time a long while back removed the orifice assembly & cleaned out the orifice for possible spider webs & trash with a cleaning device & reinstalled & still the same.
I tampered with the adjustable pilot valve screw a long while back up some to keep the pilot light from going out when the wind was blowing hard.
The flame would come out weak & flickering & not blowing the flame out strong.
I suspected it may have a crack in the heat exchanger but inspected it myself & it showed to be ok.
I do have some small cut open places in the under belly where I had to gain access to some grey plastic type polybutholene (sorry for the misspell), water pipes & repair the leaks at the hot pipes t-joints 1/2 to 3/4 inch fittings.
The belly warp had no affect on the furnace heating up cause it worked fine before when the underbelly was open when it was working before.
They seem to be the only ones that split into.
The reason I haven't been on here in quite awhile is I was diog. with Lukemia earlier stage back in June & Have been taking chemo & had to have a blood transfusion & two bone marrow biopsies & soon to have a bone marrow transplant.
On my last stage of Chemo for 6 months & should be ok after that the doctor told me.
Let me know something soon!
Thanks!
David