I do have a couple questions too.
1. I have a NG water heater with an outside door. The heater had an insulation/plastic blanket around it. The plumber indicated that this was not a good idea, due to the risk of fire. So I removed it. Still, the door is vented into the waterheater, will it be ok, or do I need to figure out some other way to insulate the heater and piping in this area?
2. About PEX. The plumber said they use PEX almost all the time now days. They use the expansion type fitting connection as shown on this web site. http://www.pexinfo.com/ I recall someone asking about fittings, and the plumber said he had maybe 2-3 connections go bad out of thousands, and that he preferred this method.
3. My SW MH does not have a ceiling exhaust fan in the bathroom (small window, yes) and I can tell that the ceiling has been painted over to cover the humidity stains. One of the archive emails asked about how to install an exhaust when there is no vent already in place. But I did not find a response to this question. Any suggestions?
Next project will be to have the termite treatment done. Then replace the skirting and decking to satify the bank.
I wanted something to keep me busy in my free time. Guess I found it.
![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)