Quick question:
Is is acceptable to "cut" (professionally at machine shop), a Nordyne telescoping roof jack? The one that was supplied with the furnace is way to long even in the fully closed position. (Cannot exchange...too much time has elapsed). If cut cleanly and evenly at the furnace side, it seems like it would be fine. Any thoughts?
Nordyne 903666A 51" -95" ( I need less than 51")
Furnace M1MC 070A
Thanks!
Todd
Nordyne Telescoping Roof Jack
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Roof replacement and roof over project - combined
by Joemontana » Mon May 04, 2020 9:02 pm » in Mobile Home Repair - 1 Replies
- 75790 Views
-
Last post by Greg
Tue May 05, 2020 5:06 pm
-
-
-
Metal roof over, SW with a peaked metal roof
by Hwystar73 » Thu Dec 17, 2020 9:25 pm » in Mobile Home Repair - 3 Replies
- 109622 Views
-
Last post by Hwystar73
Sun Jan 03, 2021 6:20 pm
-
-
- 0 Replies
- 136281 Views
-
Last post by taurolyon
Thu Jan 04, 2024 4:19 pm
-
-
Help with Nordyne electronic board
by swade1991 » Thu Aug 02, 2018 12:13 pm » in Nordyne Service & Repair - 0 Replies
- 43245 Views
-
Last post by swade1991
Thu Aug 02, 2018 12:13 pm
-
-
- 2 Replies
- 37488 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:35 am