Miller MGHA 070ABFC-05
We live in Wyoming where there is high wind. We cannot keep the pilot light lit on this furnace. Have replaced the thermal regulator. Also last time the pilot light went out and tried to re-light it actually blew flame out of it. Have not tried to re-light again, but we are in the middle of a severe blizzard and need ideas. Does it need replaced?
You may indeed need to replace it, If my memory is correct, they are not that expensive, you may want to keep a spare on hand if you are having problems.
It sounds to me like you are getting a down draft, perhaps there is a different style cap that you could put on the vent, the old wind vane style comes to mind if they still make them. Greg
It sounds to me like you are getting a down draft, perhaps there is a different style cap that you could put on the vent, the old wind vane style comes to mind if they still make them. Greg
"If I can't fix it, I can screw it up so bad no one else can either."
These are hard to troubleshoot from here. Roof-jack,pilot burner, pilot tubing, pilot orifice are some of possible problems.
May need an hvac tech to test system.
Thanks,
Robert
May need an hvac tech to test system.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
have intertherm heat pump with a 913421 control box tying to a miller 841 thermo stat ,
by hillcat01 » Mon Oct 21, 2019 7:28 pm » in Nordyne Service & Repair - 0 Replies
- 82055 Views
-
Last post by hillcat01
Mon Oct 21, 2019 7:28 pm
-
-
-
I need wiring assistance for a miller furnace serial number A0981-0685
by Timodell » Wed Nov 20, 2019 10:40 pm » in Nordyne Service & Repair - 0 Replies
- 61800 Views
-
Last post by Timodell
Wed Nov 20, 2019 10:40 pm
-
-
-
Fluctuating flue draft Miller CMF2 80 PO CONV
by ctwap2783 » Sat Feb 22, 2020 9:36 pm » in Nordyne Service & Repair - 0 Replies
- 117168 Views
-
Last post by ctwap2783
Sat Feb 22, 2020 9:36 pm
-
-
- 0 Replies
- 123291 Views
-
Last post by wogman75
Tue Jul 28, 2020 2:43 pm