this is sort of a continuation of this thread I started back in dec -I've reasoned it down to having to be ice damming up the water thats trying to move downward but is heading back under the shingle and finding a way down my walls /celiling
https://www.mobilehomerepair.com/phpbb/v ... ing+stains
wife and I figured theres not much we can do about the leak(s) which has produced several 1 to 2 inch stains along the north facing side of the mobile where the wall meets the ceiling .the best advice I got from a contractor was to shovel off the snow which my dad did for me last month ---then wait til spring to hope for stains to dry up enough to then paint over them
however - wife and I have redone all the flooring (mostly laminate in bedrooms /new linolium tiles in hallway/bath/hitchen) in the home except the living room --so we decided to go to home depot and snag some laminate for the living room .
while ripping out the old carpeting I noticed wet spots along the floor directly below the really bad batch of 1-2 inch celiling stains .I'd say in total theres probably around 1 foot worth of these wet spots when you add them all up which probably isnt too bad .The wetness seemed new and not something thats been lingering for a long time -but , I did something out of my comfort level and took off a sheet of paneling to see just how wet it was back there .Much to my pleasant surprise it was actually dry as a desert on the backside of the panelling and all the 2x4's running vertical as well as the one running along the floor and roof support were dry too .I decided to puncture the membrane so I could check out in behind the pink insulation and found that the plywood behind the pink insulation and the backside of the insulation had some frost on it -but nothing too wild and willy .I'm assuming this frost is the water that has leaked down the wall from the ice damming
I'm confused as to what I should do now -wait til things dry up on their own ? File an insurance claim and see if its worthy of gutting ?
third winter here and first time we've had this happen
crazy winter tho -alot of snow and colder than usual
there are no bathroom vent venting into the attic either -its vented through the wall instead
I've started looking at steel roofs but they probably cost more than my mobile is worth
arrgh -advice anyone ?
ice damming = roof leak
Moderators: Greg, Mark, mhrAJ333, JD
p.s -might look into this next winter but I'm not sure it would have the moxy to handle a northern canada ice buildup
http://www.heatersplus.com/easyheat.htm
http://www.heatersplus.com/easyheat.htm
- flcruising
- Posts: 606
- Joined: Mon Dec 03, 2007 2:18 pm
- Location: Florida Panhandle
The culprit to ice daming is too much heat 'leaking' to the attic. If you can insulate and seal up your attic well, the ice daming will go away.
http://www.umass.edu/bmatwt/publication ... _dams.html
http://www.energystar.gov/index.cfm?c=h ... nt_icedams
http://www.umass.edu/bmatwt/publication ... _dams.html
http://www.energystar.gov/index.cfm?c=h ... nt_icedams
[color=blue]Aaron[/color]
Actually although lack of insulation is a contributing factor the real culprit is probably lack of ventilation above the insulation. Ventilation at the eves and peek (if there is one) prevents the heat escaping from the interior from heating the underside of the roof which causes the snow/ice to melt on the roof leading to the ice dam. You need to add ventilation if possible.
- flcruising
- Posts: 606
- Joined: Mon Dec 03, 2007 2:18 pm
- Location: Florida Panhandle
Yes, forgot that part.
The articles explain completely.
The articles explain completely.
[color=blue]Aaron[/color]
- Jim from Canada
- Posts: 551
- Joined: Mon Mar 05, 2007 10:39 am
To solve the problem, you have to stop the leak. You are saying you have shingles, so I am going to assume you have a pitched roof. Likely a low slope, which is what I have. I re roofed my place. You don't have to go as drastic as I did but here is what you want to do.
Strip the shingles and repair any weak spots in the sheathing. The sheathing should be minimum 5/8" T&G OSB if your trusses are 24" OC.
Metal edging on eaves.
Cover the sheathing entirely with Ice/Water sheild (get Grace brand if you can, it is twice the price , but worth it).
Metal edging on the gable ends
Shingle and flashing.
Look at my photo album to see the job I had done. In addition to the above, I upgraded the sheathing to 5/8" Plywood, I added a 2x4, on edge to each truss to make room for more insulation in the catedral ceilings. I also upgraded to a shingle more suited to a low slope.
It rained the morning of the shingling. The roof had only the Grace on the sheathing and I had no leaks. It never will.
I plan on opening up the inside as there is no vapour barrier in the house. I will install styrofoam baffles from the eaves to the ridge vent (having a cold space between the insulation and roof is very important, unless using spray foam....use "Walltite" if you sprayfoam). I am then going to install 10" of Roxul insulation (R 36) by using both a 4" and a 6" batt. 6 mil vapour barrier is next, then finished walls.
Hope this helps
Jim
Strip the shingles and repair any weak spots in the sheathing. The sheathing should be minimum 5/8" T&G OSB if your trusses are 24" OC.
Metal edging on eaves.
Cover the sheathing entirely with Ice/Water sheild (get Grace brand if you can, it is twice the price , but worth it).
Metal edging on the gable ends
Shingle and flashing.
Look at my photo album to see the job I had done. In addition to the above, I upgraded the sheathing to 5/8" Plywood, I added a 2x4, on edge to each truss to make room for more insulation in the catedral ceilings. I also upgraded to a shingle more suited to a low slope.
It rained the morning of the shingling. The roof had only the Grace on the sheathing and I had no leaks. It never will.
I plan on opening up the inside as there is no vapour barrier in the house. I will install styrofoam baffles from the eaves to the ridge vent (having a cold space between the insulation and roof is very important, unless using spray foam....use "Walltite" if you sprayfoam). I am then going to install 10" of Roxul insulation (R 36) by using both a 4" and a 6" batt. 6 mil vapour barrier is next, then finished walls.
Hope this helps
Jim
- Jim from Canada
- Posts: 551
- Joined: Mon Mar 05, 2007 10:39 am
P.S.
While I was at it I had the eaves extended to about a 1 foot overhang. My Soffits sit higher now but I added a freize board above my siding to make up the difference. Had the freize board covered in aluminum and aluminum soffit installed. I have about $7000 put into it. I would have saved about 1/2 that if I was able to (physically, buggered my knee up) do the job myself. I have the fascia yet to do.
Jim
While I was at it I had the eaves extended to about a 1 foot overhang. My Soffits sit higher now but I added a freize board above my siding to make up the difference. Had the freize board covered in aluminum and aluminum soffit installed. I have about $7000 put into it. I would have saved about 1/2 that if I was able to (physically, buggered my knee up) do the job myself. I have the fascia yet to do.
Jim
thanks for the advice gentlemen
jim , my fellow canuck -the shingles we're done in 2004 and they are in very good shape after I inspected the roof before buying the place in 06 .former owner kept all receipts and the job was done by one of the better contractors in town so cant imagine he'd forget to use the proper sheathing etc.....but I guess you never know .
I still have the sheet of panelling off the wall and things seem to be drying up .I'm gonna sit tight and see what happens this coming weekend as its supposed to warm to +7 celcius on saturday --compare that to -35 this morning .
jim , my fellow canuck -the shingles we're done in 2004 and they are in very good shape after I inspected the roof before buying the place in 06 .former owner kept all receipts and the job was done by one of the better contractors in town so cant imagine he'd forget to use the proper sheathing etc.....but I guess you never know .
I still have the sheet of panelling off the wall and things seem to be drying up .I'm gonna sit tight and see what happens this coming weekend as its supposed to warm to +7 celcius on saturday --compare that to -35 this morning .
- Jim from Canada
- Posts: 551
- Joined: Mon Mar 05, 2007 10:39 am
Well, what I described is well above code. 24" OC trusses can have 1/2" OSB sheathing with H clips, but have you ever walked on one built that way? Not good. Code also only requires tar paper for the bottom 3' under the shingles. Again, a recipie for a leak. Keep your eyes peeled and see what you come up with, I am looking forward to warmer weather too.
Jim
Jim
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 95906 Views
-
Last post by Raktus84
Fri Aug 21, 2020 11:38 am
-
- 2 Replies
- 16065 Views
-
Last post by cjb2145b
Sun May 03, 2020 10:11 am
-
-
Leak detector on water meter spins back and forth
by caligirl » Wed Mar 04, 2020 9:34 pm » in Mobile Home Repair - 2 Replies
- 27514 Views
-
Last post by Mark440
Sat Mar 07, 2020 9:47 pm
-
-
-
Simple Question.......trying to repair toilet tank leak!
by CountryLiving34 » Fri Apr 10, 2020 10:26 am » in Mobile Home Repair - 3 Replies
- 12788 Views
-
Last post by Greg
Sat Apr 11, 2020 6:49 am
-
-
-
Questions about steel roof options for arched roof
by Reezer76 » Thu Sep 14, 2017 9:41 pm » in Mobile Home Repair - 2 Replies
- 64862 Views
-
Last post by JD
Sun Sep 17, 2017 4:31 pm
-