Our furnace has what could be described as an intermittent problem. At times, it is slow to fire. It has been getting worse though...going from once or twice every few days to twice so far today!
You hear the thermostat kick and the oil pump kicks on and on the worst one I counted, it was 10 seconds until it fired. When it did, it was quite the rumble. The next time it fired up just fine.
Any ideas?
I'm new to this so any advice is appreciated.
Miller CMF80-PG w/ Beckett Burner
Hi,
With what you described and stated, it would be best to call a Tech.
Too many variables that it could be and need proper tools and equipment to test and diagnose.
Thanks,
Robert
With what you described and stated, it would be best to call a Tech.
Too many variables that it could be and need proper tools and equipment to test and diagnose.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
intertherm standing pilot propane burner Heat Rise of 38°F spread.
by justplumducky » Fri Aug 25, 2017 10:06 am » in Nordyne Service & Repair - 0 Replies
- 51541 Views
-
Last post by justplumducky
Fri Aug 25, 2017 10:06 am
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 70779 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
- 2 Replies
- 19138 Views
-
Last post by TorstenW
Tue Mar 06, 2018 1:04 am
-
-
have intertherm heat pump with a 913421 control box tying to a miller 841 thermo stat ,
by hillcat01 » Mon Oct 21, 2019 7:28 pm » in Nordyne Service & Repair - 0 Replies
- 83301 Views
-
Last post by hillcat01
Mon Oct 21, 2019 7:28 pm
-
-
-
I need wiring assistance for a miller furnace serial number A0981-0685
by Timodell » Wed Nov 20, 2019 10:40 pm » in Nordyne Service & Repair - 0 Replies
- 62831 Views
-
Last post by Timodell
Wed Nov 20, 2019 10:40 pm
-