Page 1 of 1

What the...???

Posted: Tue Feb 22, 2011 7:17 pm
by Greg
I'm in the middle of a bathroom makeover, I pulled a panel today and this is what I found.
We bought the the home new so no modifications have been made here. In addition to the weird stud configuration you can see the gap in the insulation as well, the grey spot is the outside panel, Kind'a explains the cool breeze as well as the other gaps.

So, If anyone has a thought as to why the stud has a cross stud (off center) I would be interested.

Greg

Re: What the...???

Posted: Tue Feb 22, 2011 7:32 pm
by Harry
Hi

Maybe whoever did the build/assembly wanted to adjust the ceiling a bit....maybe.

Re: What the...???

Posted: Fri Feb 25, 2011 8:18 am
by joedirt63
maybe the stud was twisted by the knot and they sistered it to keep it staight rarher than replace it. also looks like the insulation got wet near the top. i got 2 twisted studs in my kitchen wall i have to replace this spring, outside looks 6months pregnant.lol.p.s. just think it's already boxed out for and exhaust fan. :mrgreen:

Re: What the...???

Posted: Fri Feb 25, 2011 8:36 am
by Greg
Both possibilities, The insulation at the top is all dry, I filled the gaps, and foamed the 4" holes in the floor for the 1 1/2" pipes - Funny, it SEEMS warmer.

I still have to figure a way to install a ceiling fan/light/heater assembly. I'm not real wild about cutting a hole in the ceiling. Funny, 20 years ago I thought nothing about putting a 3'x4' hole in the living room for a velux skylight, I guess it really does suck to get old!!!

Greg

Re: What the...???

Posted: Sat Feb 26, 2011 7:18 am
by joedirt63
i hate the projects where you go full steam and then you run out of time or money ,but you always have plenty of both to start some other project.

Re: What the...???

Posted: Sat Feb 26, 2011 3:53 pm
by Lorne
So much for factory building and uniformity.
Videos of these being built makes you think everything is perfectly aligned and mistakes are rare.
Excuse me for a second....................................... :lol: :lol: :lol: :lol: :lol: :D :shock: :roll: . And where do they find those old, used looking 2x4 you find in the walls?

If it weren't for crappy construction we wouldn't have anything to do.
That sister'd 2x4 looks like it was needed to support the 2x4 cross piece that may have been needed to nail something to on the other side of the wall.
Good luck on your bath.

Re: What the...???

Posted: Sat Feb 26, 2011 8:20 pm
by Greg
Lorne, Actually the outside walls are 2x6, For the most part in real good shape. The only problems I have had with rot was window sills when I did the windows. I found out the floors are OSB!!!

There is nothing on the other side of the wall except for the new bathroom fan exhaust.

Greg