Page 1 of 1
How do i got about inspecting and Fixing ductwork
Posted: Fri Jul 12, 2019 7:28 pm
I have a hole somewhere in my ductwork. I have a single wide with a single duct down the center of the house. Do i just cut a hole and peek up in there thru the vapor barrier? What materials do I use to fix any leaks?
Re: How do i got about inspecting and Fixing ductwork
Posted: Wed Jul 17, 2019 11:40 pm
I don't know if this helps to answer my question. I got up under my house and figured out what the problem was. I had water leaking near or in the duct at one time. The duct has broken off from a register about 1/3 of the way across the house but fairly close to the furnace in the closet. It is that fiberboard ducting shaped like a square. I am not sure what type of materials I need to try to patch it? Should I think about replacing it with something?