Post all other heating and cooling questions here.
2 posts • Page 1 of 1
This past week I had a new roof put on my mfg home... The roofers removed the intake vent for the blend air system (the one that was about a foot high) and replaced it with a normal roof vent which is only 2 inches off the surface of the roof.. I think being this close to the roof will create a heat / moisture issue when drawing in outside air.. I just can't find any documentation to make the roofer install the correct vent that they removed. Am looking for help.. attached picture describes my issues..
- roofprobs.jpg (63.66 KiB) Viewed 8931 times
It might also be an issue when if it snows where you are. I mean I would just ask the guy to put one on that's at least 12 inches clearance. That should be a real easy fix for the roofer.
2009 Skyline Sunwood Premier 14 x 80