M1MA070A AW flame going out

Questions about repairs and parts for Nordyne furnaces, air conditioners and heat pumps for manufactured homes including Intertherm, Mac and Miller brands. Click here for Nordyne parts.

Moderators: Greg, Mark

Locked
creimer
Posts: 2
Joined: Sun Jan 15, 2012 11:18 am

Unit runs about 30 secs and flame goes out. Runs a couple of minute and tries again with same result. After a few tries furnace shuts down with failed ignition code. I replaced the igniter/ flame sensor but issue remains. Any thoughts on my next avenue to try? Need to fix soon as it is -25c here.
Top
User avatar
Greg
Moderator
Posts: 5696
Joined: Wed Feb 28, 2007 8:01 pm
Location: Weedsport, NY

I am not the sharpest on heating units, But if you have a thermo coupler on the unit I would look at that, they are cheap and when they go bad have the same results.

Greg
"If I can't fix it, I can screw it up so bad no one else can either."
Top
creimer
Posts: 2
Joined: Sun Jan 15, 2012 11:18 am

No thermocouple on it. Electric igniter. Strange problem. Now it seems to work fine. I'm going to fall off my wallet and get it checked out by a pro.
Top
Locked
  • Similar Topics
    Replies
    Views
    Last post

Return to “Nordyne Service & Repair”