Nordyne MGHA-056AAFC-02
Thermostat works fine.
Burner may have low flame.
Blower takes about 5 minutes to come on.
Forced air out of ducts is not as warm as it used to be.
What is the problem with slow & low heat ???
Mike
Slow to Heat
Sounds like the burner isn't kicking out the proper amount of heat. Make sure your orifice isn't plugged and that the gas valve is receiving gas at the proper pressure. If all that's OK, then you may need a new gas valve. http://www.aberdeenhomerepair.com/store ... ilot-light
Mark
Mark
You can't fail if you don't try!
-
- Posts: 2
- Joined: Mon Oct 10, 2011 5:29 pm
I tried to blow out any obstructions (spider webs) in the burner tube
with compressed air.
I replaced the thermocouple. Pilot light works fine.
The burner flame still looks like it isn't a full flame.
What is the best way to clean the orifice ???
Mike
with compressed air.
I replaced the thermocouple. Pilot light works fine.
The burner flame still looks like it isn't a full flame.
What is the best way to clean the orifice ???
Mike
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 17872 Views
-
Last post by Greg
Wed Feb 06, 2019 10:36 am
-
- 0 Replies
- 20066 Views
-
Last post by nestsman
Sat Aug 19, 2017 1:47 pm
-
-
intertherm standing pilot propane burner Heat Rise of 38°F spread.
by justplumducky » Fri Aug 25, 2017 10:06 am » in Nordyne Service & Repair - 0 Replies
- 41910 Views
-
Last post by justplumducky
Fri Aug 25, 2017 10:06 am
-
-
-
Acceptable HEAT RISE number for this 20-yr. old furnace.
by justplumducky » Tue Aug 29, 2017 5:33 pm » in Nordyne Service & Repair - 0 Replies
- 33359 Views
-
Last post by justplumducky
Tue Aug 29, 2017 5:33 pm
-
-
- 0 Replies
- 34140 Views
-
Last post by David DeBord
Sun Oct 22, 2017 7:13 am