Coleman Model: DGAA056BDTA
My apologies for the length, but I want to be as detailed as possible.
Unit does pre-purge(?), I hear a click, the igniter glows, another click, flames, blower starts, unit comes on, immediately another click, flame goes out, unit remains on blowing air, 15 seconds another click, igniter glows, click, flames, click, flame goes out, 15 seconds, repeat.
It goes through the click, light, flame, click, no flame cycle five times. This entire time, the status light is solid and the unit is blowing fan-only air. After the 5th time the status light flashes one time steady (Ignition Failure) and the unit turns off completely after about 30 seconds.
If I turn off the thermostat or lower the temperature to where it no longer calls for heat (it was still calling for heat), the status light goes solid again. If it turn it back on to heat or raise the temperature to call for heat, this process starts all over again.
Before I call in the repair guys...flame sensor?
Side note: The AC portion of this unit works flawlessly.
Thanks!
Unit Starts then Stops - Ignition Failure
-
- Similar Topics
- Replies
- Views
- Last post
-
-
G.E.supplemental coil heater in wall unit
by stevenbrooks » Mon Jul 17, 2017 4:00 pm » in Service & Repair of Other Brands - 0 Replies
- 31483 Views
-
Last post by stevenbrooks
Mon Jul 17, 2017 4:00 pm
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 103304 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-
-
-
Intertherm/Nordyne feh-015ha furnace issues blower not working, unit will only turn off at breaker box
by onmypath78 » Sat Mar 16, 2019 12:11 pm » in Nordyne Service & Repair - 0 Replies
- 147651 Views
-
Last post by onmypath78
Sat Mar 16, 2019 12:11 pm
-
-
-
Nordyne Mod. E1EH-015HA split unit/eliminate cooling?
by carolina jim » Thu Oct 24, 2019 8:33 am » in Nordyne Service & Repair - 0 Replies
- 32706 Views
-
Last post by carolina jim
Thu Oct 24, 2019 8:33 am
-