Ok

So In order to remove only the sliding door I have to remove the entire lower frame ?

i felt i could make it roll better. so i adjusted the front roller and somehow made it roll way worse
now it feels like the front roller isn't rolling at all

i want to pull the door inspect the mechanism, clean and replace as needed



pics uploading now

Guys


How do you remove the sliding glass door?

I've removed the top holders and tried to lift up and in (like a santard slide door)but I'm getting caught on the inner lower lip.


Am I going to have to remove the stationary glass and try and lift the slide up and out?

Lucked out

Found a tube of roof repair

The leak was coming from a split on the seam of the tube

Was able to Seal it up from the inside


But to complicate matters have a real bad chill leaking in from the roof split in my other thread

As if my problems couldn't get any worse Noticed tonight water dripping from ceiling in batroom Cut a hole out to find this mess Roof is iced over so can't get up there now to cover it Buckets for tonight http://i136.photobucket.com/albums/q173/jaw_belize/43849A2A-9F69-4752-86F9-7DD9DC80B422_zpst0dc...

i looked up mobile home code says that (4) Multiple section homes shall be mechanically fastened every twenty-four inches at the bottom, end walls, and roof. A minimum thirty-gauge, eight-inch-wide, galvanized strip shall be centered over the peak and fastened with galvanized roofing nails at two in...

anybody watch the olmpics?

bet i can sweep better than those guys curling.

This is the inside wall on the side with the open split

So pulled up 20ft of roof cap. Only found 2 lag bolts at the very end


Both are stripped out

Nothing else within than 20 ft

Surely that's not right. Right?


Had I close up shop. Out of daylight and it's going to rain next couple days.


Figure I need another 1/4 to make gasket touch other stud

I give up!! As I lift corners the middle is coming up. Does anybody know if there is a allowable variance On the side wall and roof gap? Should stud on the roof and on walls be touching Also I am noticing that the gasket is uneven How is it attached to Both sides ? I am going to stuff pipe insulatio...

About to give up On the side where i had the split in now Left corner Center. Right corner +1. 0. O I got the rest of the structure about 3/4 inch variance Need to fine tune front door And I still have a about an inch gap on top The gasket isn't touching both sides