Search found 5 matches

by cstoliker
Sat Sep 20, 2014 11:05 pm
Forum: Nordyne Service & Repair
Topic: CMF 80 PG ignition sequence question with new 1018
Replies: 0
Views: 14745

CMF 80 PG ignition sequence question with new 1018

Nordyne CMF 80 PG Last year I replaced the ignition control module (UT 1018 series). The furness works but the start up sequence is slightly different. I just want to confirm this is normal and the furness is safe. 1* After a call for heat the induced draft motor turns on for a short time, the centr...
by cstoliker
Fri Jan 13, 2012 2:27 pm
Forum: Nordyne Service & Repair
Topic: How hot should the furnace be getting?
Replies: 5
Views: 10920

Re: How hot should the furnace be getting?

Replaced high limit switch. The funace was purchased last year (blower included) as a hole re-conditiond unit from local service center. I was wondering about that. The blower should move as much heat as the furnace produces. And come to think of it my old furnace did reach the high limit switch reg...
by cstoliker
Sun Dec 25, 2011 2:29 am
Forum: Nordyne Service & Repair
Topic: How hot should the furnace be getting?
Replies: 5
Views: 10920

How hot should the furnace be getting?

CFM 80 PG conv. Just fixed the problem with the furnace shutting itself (not detecting flame) turned out to be a bad relay in the brain wich I replaced. I am worried now the furnace may be over heating. After comming home and turning up the thermostat from 69 to 71. The air comming out of the vents ...
by cstoliker
Thu Nov 17, 2011 6:26 pm
Forum: Nordyne Service & Repair
Topic: CFM 80 PG flame sensor testing
Replies: 0
Views: 7644

CFM 80 PG flame sensor testing

CFM 80 pg. I've tracked a problem to what I believe is a faulty flame sensor.(6622500) But on this unit the flame sensor is incorporated in the ignighter. How does this work with just the two wires? Is there a way to test the flame sensor portion or bypass for diagnostic proposes? When the furnace s...
by cstoliker
Sun Feb 27, 2011 6:44 pm
Forum: Nordyne Service & Repair
Topic: Induced draft adjustment?
Replies: 1
Views: 2851

Induced draft adjustment?

Just installed a Miller cfm 80 pg Propane furnace. Need help adjusting the vent in the induced draft motor. What should the flame look like inside the window? How high should the flame be?