Greg wrote:At the very least get it dried out to prevent mold. You may end up replacing the insulation in that area as well.

Greg

Got a fan blowing in the crawl space door near it. Will have to check it to see if it dried out. I guess if it feels dry I will leave it.

We had AC problems and it looks like the drain got clogged and allowed some water to collect in the under belly in that area. I cut a small slit to let it drain and have a fan in the crawl space door for now. Should that be opened up and replace that insulation or will it dry out?

So far no luck, theirs is not as wide and does not have the extra flange on it.

Our trim is damaged around our door from a hail storm. We have normal in swing doors, the storm doors are mounted to a molding, where the siding goes into what would normaly be j channel there is this piece like j channel but wider with a lip that also goes under the molding. Any idea where I can or...

We have a Coleman EB15 with a Intertherm heat pump. We are having a issue with the thermostat not keeping a constant temp. Any suggestions on a quality replacement? I hear good comments about Honeywell. We have a Hunter now and don't know it if was worth it. Someone is usally home all the time so I ...

Got up this morning and blower was running with very little air flow. Found the a coil froze up and the large line iced up going to the heat pump with some of the lines I could see inside the heat pump iced up. Air flow has been good on the unit and filters are fairly new. Any suggestions? With the ...

Our home came with a 50 gallon single element water heater. It is on a 20 amp breaker with 12 gauge wire. Most of the heaters sold locally are 50 4500 dual element heaters, I know both elements don't run at the same time. But would I need to upgrade to a 10 gauge wire and 30 amp breaker? Old heater ...

I think I may have it fixed. finally got it to do it and be acle to get to it to check it. Felt like the blower was rapidly turning on and off. Wiggled around on things and got it to act up while playing around with the blower relay. Put a new one on it and for 24 hours it has been good, took the ol...

I think I have the banging narrowed down to the blower trying to kick in and out. The problem is so intermittent that it is hard to get a meter on things to see what is losing power. Looking at the diagram should the #2 and 5 terminals on the blower relay have power all the time. Just glanced at it ...