I have a single wide 840 sq ft mobile home all remodeled 2x6 walls ,new windows and doors. there's a Coleman DGAA 77,000 btu and 62,000 output now ,but I looked up and figured it should only be about 46,000 output for here in central Iowa. furnace is 16 yrs. old and I can get a new 56,000 80% right ...

OK the mh water that i am looking at is a Ge.brand it loads cold from the top,and my mh heater that i have has two 3" holes in the bottom for draw plus the center. so whats the difference between square or round. also I cannot find any Insulation material or amount different in any brand they a...

I disagree with that I talked to rep. at richmond and they said interior is the same , in fact btu rating is lower on a std tank. if that were the case they would all be a fire hazard

yes I understand this but, I would direct vent the std water heater which would make the same as a mh water heater, just minus the sticker and we have no codes in Iowa or local for mobile homes. so the only thing is would be Insurance

Hi, has anybody ever replaced there mobile gas water heater with a standard gas water heater and just use a direct vent, I see no difference in the specifications other than direct venting

Hi, the park manager has a run cap. that is a ngm s1-02435602000 single 7.5 440 rectangular. its made of plastic he said it would work ,is that true don't want to have a fire.

I have the manual pm me with your e-mail

OK, thanks for all your help it runs fine just on high speed cools the some temp down at the registers,

hi, i see this is a 7.5 mfd 50/60 hz 440 vac , i can get one local for 8.00 but it's a 370 vac any problems with that. if so i,ll just let it run it till i can afford a new unit motor and all

thanks for all your help

yes i have 26 vac across w and c and 120 on heat terminal , so since the fan motor is a grumbling at start up for a few seconds could it be a bad motor ?

no it runs fine regular cycle , just on high speed

Hi, I have a coleman- DGAA and split a/c system . just turned on heat for the season in iowa. however the blower will only run on high speed . wires are right on the thermostat & control board if i take the high speed wire off the cool terminal fan won't run , only with high speed on cool termin...