I don't understand why the water heater would go out by removing it from the room. This is a good chance to drain your tank, flush it out good and add a new anode. Your tank should still be good. Then plum it in properly using pex, a heat trap if required, shutoffs, etc... If you do think of replaci...

I have a propane fireplace in my mobile home. It currently uses a 100lb tank sitting outside with a valve for refilling from a truck. I'd like to get rid of this tank and replace it with two 25 or 30lb tanks. I only use the fireplace as a luxury and not primary heat so I don't go through enough prop...

All good. Mark sent me a direct link for the manual via email. You guys are the best.

Thanks for all the help.

Hey, Glad you got a response...would you mind posting back after the link is reset or if it gets overlooked in Mark's busy world. Just want to make sure that you get it, also will lock this post once everything is satisfactory. Thanks again, Yanita Ok no prob. Mark said he is on the road so would g...

Actually Mark got back to me. I had to send an email to [email protected]

Thanks for all the help guys. He says he'll reset the link for me in the next day or 2.

Still no reply. I just sent an email to [email protected]

Hopefully that will help.

I left an email at the ordering site where it said "If you have problems contact us" but have yet to see a reply. How do I contact Mark?

I was viewing my online account for orders, and I saw my previous order I made for the Mobile Home Repair Manual. So I viewed that order in order to download it. All I see is the manualintro.wmv file. How would I go about downloading the manual.pdf? It seems to me that the link to the .pdf file is m...

Forgot to mention if your unsure about anything to use a qualified electrician to do the work. Just knowing where to route the wire is only 10% of the job. If you don't do proper joints or connect the neutral to the wrong terminals, things will work, but personal injury or fire may occur down the ro...

They also sell that plastic do-it-yourself gutter stuff at hardware stores. Seems easy enough to install and you don't require a professional to form a 1-piece aluminum gutter from a roll of shet metal. I'd look into that. Also you can get screen to insert in there to keep debris out. Also you can h...

Ok well I read through a ton of posts. And I'm starting to get to know a bit of the unknowns I was unsure about. I am also going to download the book by Mark for only $22. that should answer all the unknowns I have i detail. Is there a way I can start a thread for my particular build and keep you gu...

If you want the quick solution you can splice a new piece of cable off the current switch and run it to your new location a few feet over. Then where the old switch was cover the box with connections with a blank plate. You can run the cable to the side by cutting out your panelling to drill through...

Usually they put the left side with lights all together, and the right side all together. The reason the kitchen works is because those are all required to be dedicated circuits. If you lost power to all your circuits it could be a faulty breaker. Just cause it's turned on doesn't mean it's good. Or...

Thanks for the reply. I will have to look into the book and order it up one of these days. I also wasn;t thinking of the transition form vaulted to flat. There is half a wall at this point now...the division between bathroom and closet. The other half is wide open entry to the kitchen. I'll have to ...

I recently purchased a 1992 16x72 mini home. It's not finished very well...previous owners didn't have a clue. Paint job covers floor and switches, etc... Hardwood floor scratched to death from all the cats. Toilet leaked and rotted floor, so I had to reinstall toilet and wedge it cause it's 1/2 inc...