Blend Air System
This past week I had a new roof put on my mfg home... The roofers removed the intake vent for the blend air system (the one that was about a foot high) and replaced it with a normal roof vent which is only 2 inches off the surface of the roof.. I think being this close to the roof will create a heat / moisture issue when drawing in outside air.. I just can't find any documentation to make the roofer install the correct vent that they removed. Am looking for help.. attached picture describes my issues..
You do not have the required permissions to view the files attached to this post.
It might also be an issue when if it snows where you are. I mean I would just ask the guy to put one on that's at least 12 inches clearance. That should be a real easy fix for the roofer.
2009 Skyline Sunwood Premier 14 x 80
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Disable Blend Air ll Attic fan
by 777stickman » Fri Nov 17, 2017 5:05 pm » in Coleman Service & Repair - 0 Replies
- 43663 Views
-
Last post by 777stickman
Fri Nov 17, 2017 5:05 pm
-
-
-
Upflow vs Downflow Air: Seeking Opinions
by rockncountry101 » Tue May 30, 2017 8:37 am » in Mobile Home Repair - 4 Replies
- 23712 Views
-
Last post by Mark440
Tue Jun 20, 2017 1:12 pm
-
-
-
DGAT Series furnace air-conditioning issue
by minnie1967 » Thu Jul 13, 2017 9:48 am » in Coleman Service & Repair - 0 Replies
- 60591 Views
-
Last post by minnie1967
Thu Jul 13, 2017 9:48 am
-
-
- 1 Replies
- 22837 Views
-
Last post by Greg
Tue Dec 26, 2017 7:33 pm
-
- 0 Replies
- 32995 Views
-
Last post by Elainesplay
Sat Jul 13, 2019 9:54 am