HVAC repairman replaced blower on unit ($375.00), but could not get it to work, so 2nd service man called in.
2nd Repairman, said problems must be in control board, so he installed a fan contactor and set up the motor on high speed. Which is okay for cooling, but motor is supposed to run on low speed for heat (I think).
How would I change this motor over to low speed or is it okay on high?
Please no more repairmen as I now have over $1100.00, with the last 2.
The motor diagram shows Black and White wires for High Speed
Blue and White wiresfor Med speed
Red and White wires for Low speed
Thank you in advance.
Blower Questions E1EH1-015A
Remove the black wire and put the red wire in its place.
Mark
Mark
You can't fail if you don't try!
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Questions about steel roof options for arched roof
by Reezer76 » Thu Sep 14, 2017 9:41 pm » in Mobile Home Repair - 2 Replies
- 64753 Views
-
Last post by JD
Sun Sep 17, 2017 4:31 pm
-
-
- 9 Replies
- 11702 Views
-
Last post by Greg
Sat Oct 20, 2018 9:01 am
-
-
Deck footing and porch design questions
by mdnagel » Thu Aug 15, 2019 1:28 pm » in Mobile Home Repair - 6 Replies
- 32834 Views
-
Last post by mdnagel
Tue Aug 20, 2019 6:44 pm
-
-
- 8 Replies
- 10838 Views
-
Last post by Mark440
Wed Dec 04, 2019 10:09 am
-
-
Hello and siding/window questions
by therealhotrod » Sat Dec 28, 2019 12:35 am » in Mobile Home Repair - 2 Replies
- 21715 Views
-
Last post by therealhotrod
Sat Dec 28, 2019 1:25 pm
-