New Furnace roof vent
We recently had a new high efficiency furnace installed. The installer vented the furnace through the old chimney/roof jack. He took off the cap off the old roof jack, ran the pvc pipes up and cut a piece of sheet metal to place over the pipes and bent the edges over the existing jack, then sealed around the pipes with some orange sealant. It probably works fine, but it looks horrible. The pipes look like they are just floating out of the old roof jack and I think they are much taller than needed - 3 ft++ over roof level (need 1 foot above expected snow level??) My question is, is there some type of cap to place over the old roof jack that has holes for the 2 pvc pipes, and is there some type of rubber boot or something to seal around the pipes??
Hi,
Locate someone who is reputable to correct the mess and turn that hvac impersonator into the BBB IF he does not refund labor cost and/or cover cost to correct what he done.
That is best answer I can give with what you stated.
Thanks,
Robert
Locate someone who is reputable to correct the mess and turn that hvac impersonator into the BBB IF he does not refund labor cost and/or cover cost to correct what he done.
That is best answer I can give with what you stated.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 103408 Views
-
Last post by JenniferK
Wed Nov 22, 2017 12:52 am
-
- 1 Replies
- 3340 Views
-
Last post by Greg
Sun Oct 14, 2018 8:41 am
-
-
Doublewide - Vent or Leave roof Non-vented?
by 73Viking » Fri Jun 14, 2019 7:00 pm » in Mobile Home Repair - 2 Replies
- 11342 Views
-
Last post by 73Viking
Sat Jul 13, 2019 12:21 pm
-
-
- 2 Replies
- 50562 Views
-
Last post by Mark440
Thu Apr 11, 2019 11:15 am
-
- 2 Replies
- 4576 Views
-
Last post by Greg
Mon Sep 11, 2017 6:27 pm