Goodman furnace GMNT060-3

Questions about repairs and parts for other brands of furnaces and air conditioners. Please note that our speciality is Coleman and Nordyne products, so our knowledge of other brands may be limited.

Moderators: Greg, Mark

Locked
supercomputerguy
Posts: 1
Joined: Sun Dec 20, 2009 11:26 pm
Contact:

I have a Goodman furnace GMNT060-3 and having an intermittent problem where the furnace goes off and a single blinking light about every two of three seconds. This can happen days or weeks, months apart. To restart I turn off the furnace power switch and turn it back on the furnace resets and starts up. Five different techs have looked at the problem, cleaned parts and, one the cleaned the flame sensor, but same problem. The last one replaced the high limit switch they said the furnace was going to hot over 170 degrees and cycling on the thermo disk. The last techs did a complete test and check airflow etc.
The Goodman furnace has preformed well, until this gremlin started a year ago and techs seem to be puzzled and out of ideas—plus service & part replacement are not cheap. Furnace filters are kept clean/replaced, gas pressure has been checked, as have other parts/wiring, venting. Defiantly seems to be a puzzler…any help/suggestions accepted…Don
User avatar
Robert
Moderator
Posts: 6413
Joined: Wed Feb 28, 2007 12:07 am
Location: Tennessee

Is there a diagnostic code list to tell you what the flashes mean ?


Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
Locked
  • Similar Topics
    Replies
    Views
    Last post