• HOME
• ARTICLES
• FORUM
• BOOKS & PARTS
• HVAC
• ENERGY

Basements - Installing the Support Beams

Step 1 - Place the metal I-beams from side-wall to sidewall. There will be approximately 1 beam per 10' (left and lower left).

Step 2 – Set the support poles down the middle to support the center weight of the home (lower right).

Step 3 – Have the house mover lower the home onto the basement walls (no picture).

Exterior Finish Work

Step 1 - Once the house is lowered down, wrap 6 mil sheathing around the basement walls and carefully backfill. Backfill half way up with pea rock and the remainder of the way with dirt. The dirt should be compacted as its filled (left).

Step 2 – Install the window wells. Ideally, a piece of drain pipe from the window well should be connected to the drain tile system before any backfilling is done. If not that, then the windows should have a cover (left). Finally, install siding on the part of the basement walls that are exposed above the ground (no picture).

Interior Finish Work

Step 1 – Add insulation and a vapor barrier to the exterior walls (left).

Step 2 - Cut an opening into the home and construct the stairs. The stairs will have to be located in the middle of one side of the home, presumably in an area that will involve the least amount of obstructions. Even then, most likely at least one steel beam will have to be cut and braced from below with posts.

Step 3 - Finish off the rest of the basement to your liking (left).

Building the Basement | Basement Options

Trouble finding what you are looking for?  Try a Search Below

	Web mobilehomerepair.com